Samsung SRD-470D User Manual

Also see for SRD-470: User manual Specifications User manual Quick guide

Contents

46_ using the DVRusing the DVR• Duration : Sets the alarm duration for the alarm signal and beep sound.- If <BEEP> was selected, a beep will sound.- If <All> was selected, both beep sound and alarm signal through rear side ports will output.M  <Check> status means that the HDD is operating but it has problems that require technical examination.( ) appears on the Live screen. <Replace> status means that the HDD has defect and requires immediate replacement.( ) appears on the Live screen.4. When the HDD Alarm setup is done, press <OK>.Remote DevicesYou can set the RS-485 communication for use of PTZ Camera and system keyboard with the DVR.Using the mouse may help make setup easier.1. Use the up/down buttons ( ) in <Device> window tomove to <Remote Device>, and press [ENTER] button.2. Use direction buttons ( ◄ ►) to move to the desireditem, and press [ENTER] button.3. Set the values of each communication setup of the remotedevice.• Baudrate : Baud rate settings of the DVR, PTZ camera andsystem keyboard should be matched for proper operations.4. Make sure to match IDs of the DVR, System Keyboardand Remote Control, and press <OK>.M  For changing the remote control’s ID, refer to “Changing the Remote Control ID”. (Page 12)POS DevicesYou can set properties of POS devices connected to the DVR.A POS device connection requires channel, preset, and Port/Ethernet settings.Using the mouse may help make setup easier.1. Use the up/down buttons ( ) in <Device> window tomove to <POS Device>, and press [ENTER] button.2. Use direction buttons ( ◄ ►) to move to a desireditem, and set the value.• POS USE : When selected <POS USE>, DVR and POS willbe connected.J  If you change settings for the device and press <OK> whilethe <POS USE> is not checked, the changes for POS devicewill not be saved.System Keyboard OFF ID 01Remote Control ON ID 00Baudrate Parity Data Stop Bit Transfer type9600  None  8  1  Half DuplexRemote DeviceOK CancelPOS USEPOS CH Preset  Port/Ethernet1 None No preset None2 None No preset None3 None No preset None4 None No preset NonePOS DeviceOK CancelPOS Device Setup