● Positioner Settings: Configures the aerial positioner.Positioner: Enables or disables the positioned control.Positioner Type: Sets the positioned type between DiSEqC 1.2 and USALS (Universal SatelliteAutomatic Location System).– My Longitude: Sets the longitude for my location.– My Latitude: Sets the latitude for my location.– Satellite Longitude Settings: Sets the longitude of user defined satellites.User Mode: Sets the position of satellite aerial according to each satellite.If you store the current position of satellite aerial according to a certain satellite, when the signalof that satellite is needed, the satellite aerial can be moved to pre-populated position.– Satellite: Selects the satellite to set the position for.– Transponder: Selects a transponder from the list for signal reception.– Moving Mode: Selects the movement mode between discrete and continuous movement.– Step Size: Adjusts the step size degrees for the aerial rotation. Step Size is available whenMoving Mode is set to Step.– Go To Stored Position: Rotates the aerial to the stored satellite position.– Aerial Position: Adjusts and stores the aerial position for the selected satellite.– Store Current Position: Stores current position as the selected positioner limit.Installer Mode: Sets limits to the scope of movement of satellite aerial or reset the position.Generally, installation guide uses this function.– Limit Position: Selects the direction of the positioner Limit.– Aerial Position: Adjusts and stores the aerial position for the selected satellite.– Store Current Position: Stores the current position as the selected positioner Limit.– Go to zero: Moves the aerial to the reference position.– Reset positioner limit: Allows the aerial to rotate over the full arc.● Reset all settings: All satellite settings will be reset to the initial values.
