Samsung UN40D6400UF User Manual

Also see for UN40D6400: E-manual User manual User manual E-manual E-manual

Contents

English - 9Plug & Play (Initial Setup)When you turn the TV on for the first time, a sequence of on-screen prompts will assist in configuring basic settings. To turn onthe TV, press the POWERP button.✎ Plug & Play is available only when the Source is set to TV.✎ To return to the previous step in the Plug & Play sequence, select Previous, and then press ENTERE.✎ Before turning on the TV, make you have connected the TV to an antenna or cable connection (p. 8).1 Selecting the OSDLanguagePress the ▲ or ▼ button to select a language. Press ENTERE twicewhen done.2 Setting the Network Set up your network connection. Press the ENTERE button to start.If you do not know your network set up information or want to set to itlater, select Skip. We suggest you skip network connection setup nowand refer to “Network menu” in the e-Manual for set up requirements andinstructions, and the Network Connection section of this manual (Page 15).You can set up the network connection later using the Network menu.3 Selecting the usagemodePress the ▲ or ▼ button to select Home Use, and then press the ENTERE button twice.Select the Home Use mode. Store Demo mode is for retail environments.4 Setting the ClockModePress the ▲ or ▼ button to select Auto or Manual, and then press ENTERE twice.✎ If you selected Auto, you’ll go to the Time Zone and DST screen. Select Time Zoneor DST, and then press ENTERE. On the Time Zone screen, use the ▲ or ▼button to select your zone, and then press ENTERE. On the DST screen, press,ENTERE, then select whether to turn DST (Daylight Savings Time) on or off. Whendone, press ENTERE.✎ If you selected Manual, you’ll go to the Date and Time screen. Select Date or Time,and then press ENTERE. Then, use the number buttons or the ▲ or ▼ button toset the date or time. Use the ◄ or ► button to move between entry fields. Whendone setting the Date and Time, select Next, and then press ENTERE.5 Selecting searchoptions for auto tuningPress the ▲ or ▼ button to select Air or Cable, and then press ENTERE. A checkappears on your selection. Select Next, and then press the ENTERE button. You cancheck both if you have both connected.✎ If you selected Cable, you’ll go to the Cable System screen. Use the ▲ or ▼button to select Digital or Analog, and then press. ENTERE. Use the ▲ or ▼button to select the correct cable signal format - STD, HRC, or IRC - and then pressENTERE. Most cable systems use STD. Select the correct cable signal format forboth the Digital and Analog systems.✎ When done, select Next, and the press ENTERE.6 Selecting andmemorizing channelsThe channel search will start automatically. This can take up to 30 minutes.For more information, refer to Channel → Auto Program in the e-Manual.✎ Press the ENTERE button at any time to interrupt the memorization process.7 Enjoy your TV. If you want to watch a broadcast program, select Close.If you want to enjoy Smart Hub, select Smart Hub. Smart Hub will start. For more detailedinformation, refer to “Smart Hub” in the e-Manual.If You Want to Rerun Plug & Play...O MENU → System → Plug & Play → ENTERE✎ NOTEy To change the TV’s setting from Store Demo to Home Use when not in Plug & Play, press the volume button on the TV.When you see the volume bar on the screen, press and hold the MENU button on the TV for 5 sec.PPOWERINF