12 D I G I T A L S A T E L L I TDSB-H670ND I G I T A L S A T E L L I TDESCRIPTIONInserting the batteries in your remote controlBefore you can use your remote control, you must insert the two supplied AA batteries as follows:1. Push the catch at the bottom of the remote control battery cover up, then lift off the cover.2. Insert the two batteries as shown below, be sure to match the + and - marks on the batteries totheir respective marks inside the batteries compartment.3. Replace the battery cover, by inserting the tab at the top of the cover first, then pushing thecover into place.Do not leave flat batteries in your remote control. Replace both batteries in the same time.Do not dispose of used batteries with your domestic rubbish.Used batteries should be recycled at the end of their useful life.Where to place your receiverPlease make sure that your TV, VCR and receiver will be placed in a location that is convenientlylocated.• Near an easily-accessible mains wall socket.• Within reach of your satellite-dish leads