Samsung WF210ANW/XAA Fast Track Troubleshooting

Also see for WF210ANW/XAA: Quick guide User manual

Fast Track TroubleshootingModel: WF210ANW/XAAPublication # tsWF210 Revision Date 06/16/2011Quick Test Mode:To enter press Spin, Soil, & Powersimultaneously with the power off.1. All LED’s light up and the washer beeps as itenters the Quick Test Mode.2. The unit displays the software version.3. After the displaying the software version, turnJog dial CCW until version disappears.Press Spin to test Door Lock/Unlock circuit.Press Temp Key (with door locked) to cycle throughthe Water Valves circuit test in this order: Cold Main,Bleach, Hot, then off.Press Soil Key to test the HeaterPress Signal Key to test the PumpService Mode:This mode allows more detailed operation tests and trou-bleshooting, to enter press Signal & Extra Rinse simulta-neously for three seconds with the power on, the displaywill change to 000While in Service Mode (the Service Mode can be enteredwhile the unit is in a wash cycle) the following tests canbe performed:Quick Spin Test = Delay Start & Temp: This acceleratesthe drum motor from 0 to maximum RPM over a few min-utes. Press the Start/Pause button during the test to hold itsspinning speed up to 10 min. before going back to Quick SpinTest Mode, return to spin with Delay Start & Temp.CycleCount = Press the Signal button to see how many times theunit was used.Software Version # = Press the Soil Level button to see thesoftware version informationFault Code Test = Press the Spin button to view the storedfault codes – then turn Dial to view error codes (Push Start/Pause while the code is displayed to view the number of cy-cles since the error occurred, push Start/Pause again to getback to faults)Peripheral (Main PCB) input Tests, enter Service Mode,press the Extra Rinse key until the display shows (ln) .1. Turn the Dial CCW to Normal, Temperature will be dis-played in Celsius.2. Turn the Dial CCW to Heavy Duty, Temperature will be dis-played in Fahrenheit .3. Turn the Dial CCW to Perm Press, The door switch statuswill be displayed (CL if Closed, OP if Open).4. Turn the Dial CCW to Rinse + Spin The door lock Switchstatus will be displayed (UL if unlocked, LO if locked).5. Turn the Dial CCW to Quick Wash, the water level fre-quency will be displayed, the frequency will change as the unitIMPORTANT SAFETY NOTICE – “For Technicians Only” This service data sheet isintended for use by persons having electrical, electronic, and mechanical experienceand knowledge at a level generally considered acceptable in the appliance repair trade.Any attempt to repair a major appliance may result in personal injury and propertydamage. The manufacturer or seller cannot be responsible, nor assume any liability forinjury or damage of any kind arising from the use of this data sheet.Spin Only option:Power on, Press and hold Spin until display changes.Press Spin to select spin time.Press Start/Pause to start cycle, Normal Cycle 10/12minutes, Heavy Duty Cycle 11/13 minutes, DelicateCycle 8 minute. Spin speed varies with cycle.EEPROM Clear CheckPower On, Press Delay Start, Signal and Power Key atthe same time. Good = Goo Fail = FAIAll memory will be cleared, including Fault CodesThis should be done after a new Main PCB is installedFabric Softener Dispenser Test:Start Rinse and Spin Cycle. After fill is completedremove detergent drawer, place towel below openingand within 3 minutes the dispenser will activatePlease Note: There areSerial # changes on thismodel, verify you are order-ing the correct parts for theSerial # you are servicingby reviewing Bulletins.