Samsung WF219ANW/XAA Fast Track Troubleshooting

Fast Track TroubleshootingModels:WF219ANW/XAAWF219ANB/XAAPublication # tsWF219 Revision Date 1/15/2010Quick Test ModeNote: This test erases all faults and memory:To enter press Spin, Soil, & Powersimultaneously with the power off.1. All LED’s light up and the washer beeps as itenters the Quick Test Mode.2. The unit displays the software then clears theEEprom.3. After the displaying the software version, Jogdial CCW to display “F4”If EEEE is displayed the PCB ass’y is defective.4. When the model version (F4) is displayed. Pressthe following keys to test the various componentsPress Temp Key to cycle through the Water Valvescircuit test in this order: Cold Main, Bleach, Cold Main& Bleach for Fabric Softener, Hot, then off.Press Spin Key to test the motorPress Soil Level to test Door Lock/Unlock circuit.Press Signal Key to test the PumpService Mode:This mode allows more detailed operation tests and trouble-shooting, to enter press Signal & Extra Rinsesimultaneously with the power on.While in Service Mode the following tests can be performed:Quick Spin Test = Delay Start & Spin: This acceleratesthe drum motor from 0 to maximum RPM over a few min-utes. Note: Stay with the washer during this test, out of bal-ance detection is bypassed and the door may not lock.Press the Start/Pause button during the test to hold its spinningspeed for 10 minutes before going back to Quick Spin TestMode.Cycle Count = Press the Signal button to see how many timesthe unit was usedSoft Ware # = Press the Soil button to see the software versioninformationFast Time Down = Press the Temp button to advance to thenext cycleFault Code Test = Press the Spin button to view the stored faultcodes – then turn Dial to view error codes (Push Start/Pausewhile the code is displayed to view the number of cycles sincethe error occurred)Peripheral (Main PCB) input Tests1. Select Extra Wash. Then turn the Dial so that the Normal isturned on. Next, press the Start/Pause Key. The WaterTemperature will be displayed in Fahrenheit.2. Select Extra Wash. Then turn the Dial so that the White isturned on. Next, press the Start/Pause Key. The door status willbe displayed (OP if open, CL if closed).3. Select Extra Wash. Then turn the Dial so that the Wool isturned on. Next, press the Start/Pause Key. The door lockSwitch status will be displayed (UL if unlocked, Lo if locked).4. Select Extra Wash. Then turn the Dial so that the Perm Pressis turned on. Next, press the Start/Pause Key. The WaterFrequency will be displayed.IMPORTANT SAFETY NOTICE – “For Technicians Only” This service data sheet isintended for use by persons having electrical, electronic, and mechanical experienceand knowledge at a level generally considered acceptable in the appliance repair trade.Any attempt to repair a major appliance may result in personal injury and propertydamage. The manufacturer or seller cannot be responsible, nor assume any liability forinjury or damage of any kind arising from the use of this data sheet.Location considerationsDo not install your washer in areas wherewater may freeze, since your washer willalways maintain some water in its watervalve, pump, and hose areas. This can causedamage the belts, the pump, hoses and othercomponents. Operating temperature shouldbe above 60°F/16°C.1