Samsung WF361BVBEWR/A1-0001 User Manual

Also see for WF361 Series: User manual User manual User manual User manual Technical information

Contents

MEETING iNSTALLATiON REQUIREMENTSElectrical supply120 Volt 60 Hz 15 AMP fuse or circuit breakerIndividual branch circuit serving only your washer is recommended.Your washer is equipped with a power cord.Z_ Never use an extension cord.CAUTIONGroundingELECTRICAL GROUNDING IS REQUIRED FOR THIS APPLIANCE.This appliance must be grounded. In the event of malfunction or breakdown, grounding willreduce the risk of electric shock by providing a path of least resistance for electric current.This appliance is equipped with a power cord having a three-prong grounding plug for use in aproperly installed and grounded outlet.The plug must be plugged into an appropriate outlet that is properly installed and grounded inaccordance with all local codes and ordinances.,4X Improper connection of the equipment-grounding conductor can result in a risk of electrical......._ shock. Check with a qualified electrician or serviceman if you are not sure whether theappliance is properly grounded. Do not modify the plug provided with the appliance. If itdoes not fit the outlet, have a proper outlet installed by a qualified electrician.IMPORTANT SAFETY PRECAUTIONSTo prevent unnecessary risk of fire, electrical shock, or personal injury, all wiring andgrounding must be done in accordance with the National Electrical Code ANSI/FNPA, No.70 Latest Revision and local codes and ordinances. It is the personal responsibility of theappliance owner to provide adequate electrical service for this appliance.Z_ Never connect the ground wire to plastic plumbing lines, gas lines, or hot water pipes.CAUTIONWat e rTo correctly fill your washer in the proper amount of time, water pressure of 20-116 psi (137-800 kPa) is required.Water pressure less than 20 psi (137 kPa) may cause water valve failure, may not allow the watervalve to shut off completely, or may extend the fill time beyond what your washer controls allow,resulting in your washer turning off. A time limit is built into the controls to prevent flooding if ahose becomes loose.The water faucets must be within 4 ft. (122 cm) of the back of your washer to match the inlethose provided with your washer._ ccessory inlet hoses are available in various lengths up to 10 ft. (305 cm) for faucets thatare further away from the back of your washer.To avoid the possibility of water damage:Have water faucets easily accessible.Turn off faucets when the washer is not in use.Periodically check that there is no leakage from the water inlet hose fittings.Check all connections at the water valve and faucet for leaks.WARNIN_Drain facilityIf you use a standpipe, the recommended height of the standpipe is 18 in (46 cm). The drain hosemust be routed through the drain hose dip to the standpipe. The standpipe must be large enough toaccept the outside diameter of the drain hose. The drain hose is attached the factory.setting up your washer 13WF361 363 365-02832J-02 £N.indd Sec5:13 2012-07-24 C-8:08:40 I