Regulatory information865. Appendix13United States of AmericaFederal communications commission (FCC)Intentional emitter per FCC Part 15Low power, Radio LAN type devices (radio frequency (RF) wirelesscommunication devices), operating in the 2.4 GHz/5 GHz Band, may be present(embedded) in your printer system. This section is only applicable if thesedevices are present. Refer to the system label to verify the presence of wirelessdevices.Wireless devices that may be in your system are only qualified for use in theUnited States of America if an FCC ID number is on the system label.The FCC has set a general guideline of 20 cm (8 inches) separation between thedevice and the body, for use of a wireless device near the body (this does notinclude extremities). This device should be used more than 20 cm (8 inches)from the body when wireless devices are on. The power output of the wirelessdevice (or devices), which may be embedded in your printer, is well below theRF exposure limits as set by the FCC.This transmitter must not be collocated or operation in conjunction with anyother antenna or transmitter.Operation of this device is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept anyinterference received, including interference that may cause undesiredoperation of the device.Wireless devices are not user serviceable. Do not modify them in any way.Modification to a wireless device will void the authorization to use it.Contact manufacturer for service.FCC statement for wireless LAN use:While installing and operating this transmitter and antenna combinationthe radio frequency exposure limit of 1m W/cm2 may be exceeded atdistances close to the antenna installed. Therefore, the user must maintaina minimum distance of 20cm from the antenna at all times. This devicecannot be collocated with another transmitter and transmitting antenna.14Russia/Kazakhstan/Belaru only
