|
SAMSUNG This Document can not be used without Samsung’s authorization 5-1Adjustment5. Adjustment■ After you replace the electronic parts, you must make adjustments for each adjustment item in ST1000.■ The following table shows the necessary adjustment item for replacing each part.5-1 Basic guide for adjustment1. After changing each parts, please adjust the camera by using below table.Process Adjustment section Main PCB CMOS Shutter EVF Top Flash EquipmentADJ_01CIS Tilt ● ● ● ●Input CIS DOT Data ● ●Shutter Speed ● ● ●ADJ_02 Dust Reduction ● ●ADJ_04OB adj ● ●AFE Gain adj ● ● ●ISO sensitivity adj ● ● ●ADJ_05 VFPN adj ● ●Defective Pixel adj ● ●ADJ_06 AWB Low adj ● ● ●ADJ_07Internal Strobe adj ● ●AWB Strobe adj ● ●AF secondary strobe adj ● ● ● ●ADJ_08 Proximity Sensor adj ● ● ●2. Needed tools for adjustment- ADJ_00 : Kyoritsu (RSM-5000)- ADJ_01 : Kyoritsu (RFS-5910)- ADJ_04 : Light Source Box ( 5500K±100, Lv. 12 )- ADJ_06 : Light Source Box ( 3100K±100, Lv. 11 )- ADJ_07 : Gray chart(18%) for FLASH & AWB adjustment , Dark Room3. Adjustment program file- To adjust the CIS Dot & Shutter Speed, you need to Shutter Adjustment.zip software file.First of all, please un-zip the S/W and install it as below.1) Please un-zip the attached S/W file on the root of C:2) Please run the ‘install.bat’ inside the /USB_Filter sub-folder.3) Please run the ‘_2005vcredist_x86.exe’ inside the /VC++ Patch sub-folder.4) Please run the NXShutterSpeed.exe program.- To adjust the other sections, please save the each adjustment data to the SD card.The adjustment file name must be “nx10.adj” and save it with info.tg and info.tgw files to root of SD card.
PreviousNext Related manuals for Samsung NX10 This manual is suitable for:  manualsdatabase Your AI-powered manual search engine |
