8General Operation■■ If no operation is performed after the TV hasbeen switched on by the ON TIMER, such as ifyou are not at home, the TV will beautomatically switched off after approximately2 hours■■ If the TV is already switched on when the timeset for the ON TIMER has been reached, onlythe programme position will be changed to theset programme position.■■ Cancelling ON TIMER. To cancel the ONTIMER, press the VOLUME ( + or - ) button toset it to “ON 0:00” while the ON TIMER screen isshown. Switching off the TV by pressing theMains ON/OFF button will also cancel the ONTIMER settings.The OFF TIMER will switch off the TV automatical-ly after 30 minutes, 1 hour, 1 hour and 30 minutes,or 2 hours.■ Just one minute before switching off the TV,“OFF 0:01” will be display on the screen.■ To cancel the OFF TIMER, select “OFF 0:00”by pressing the VOLUME (+ or - ) button.■ The OFF TIMER cancels when the TV set isturned off or if a power failure occurs.When the ON TIMER is set. TV will automaticallybe switched On to the selected programme positionwhen the specified time has elapsed.Programme position for when TV isswitched ON by ON TIMER.❒ Off Timer1 Press the TIMER button.OFF 0:002 Press the VOLUME ( + or - ) button to selectthe time period.❒ On Timer1 Press the TIMER button twice.ON 0:00 2 (ON TIMER setting mode)2 Press the VOLUME ( + or - ) button. The settime will be increased or decreased by 10minutes each time the button is pressed ; themaximum time which can be set is 24 hours.3 Use Direct Programme Selection to insertprogramme position for when TV is switchedon by ON TIMER. (see page 7.)❒ On Timer (Continued)Normally, set the colour system to “AUTO”, if theclear picture cannot be obtained even when thebroadcasting or AV signal is received, press theRECALL/COLOUR SYSTEM button repeatedlyuntil the optimum image can be produced.(Refer to Broadcast Transmission System Listindicated by the last of this page in a setup ofColour System.)Each time the RECALL/COLOUR SYSTEM but-ton is pressed, colour system changes as follows;To set the sound system, make it during Semi-AutoTuning or Manual Tuning mode.When the sound is not clear or no sound is pro-duced on a programme number position, selectsound system repeatedly until the optimum soundis obtained.(Refer to Broadcast Transmission System Listindicated by the last of this page in a setup ofSound System.)To select sound system:■ Press the SOUND SYSTEM button to select thesound system directly. The sound system will bememorized automatically.Note:Colour system is displayed according asColour system option.6AUTO 6PAL6NTSC6NTSC4.43Colour and Sound System❒ Setting of the Colour System ❒ Setting of the Sound Systemor:1) Select “SIF” with the Programme UP orDOWN button in the Semi-auto or ManualTuning mode. Then press the VOLUME (+ or-) button to select a optimum sound system.