Sanyo DP19649 Owner's Manual

Also see for DP19649 - 720p 18.5" LCD HDTV: Owner's manual Setup guide Service manual Service manual Service manual

Contents

19 ENGLISHDISPLAYPress DISPLAY to display the current information onthe screen.When the TV receives a digital signal, the digitalinformation will appear.62-001 HDTV Moving Picture1CH-1DigitalNo Program Information is availableSleep TimerOffEnglishFull1080iAirTV-MAChannel number• Station name•Channel label (if preset)• Broadcast program name•V-Chip rating• Signal type•Sleep timer• Audio language•Program guide• Picture size•Resolution•When the TV receives an analog signal, the analoginformation will appear.14Analog CableSleep TimerOffMonoFull480iChannel number• Channel label (if preset)•V-Chip rating• Signal type•Sleep timer• Picture size•Audio information(Stereo, SAP or Mono)• Resolution•Press DISPLAY again to clear the call display.NOTE:After a few seconds, DISPLAY screen will return tonormal TV-operation automatically.RECALLThis button allows you to go back to the last channelselected by pressing RECALL. Press RECALL again toreturn to the last channel you were watching.MUTEPress MUTE to switch off the sound. The TV’s soundwill be silenced and “Mute” will appear on the screen.The sound can be switched back on by pressing thisbutton again or the VOL + or –.SLEEPTo set the TV to turn off after a preset amount of time,press SLEEP on the remote control. The clock willcount up 10 minutes for each press of the SLEEP but-ton (Off, 0h 10m, 0h 20m, ..., 2h 0m). After the sleeptimer is programmed, the display will appear brieflyevery ten minutes to remind you that the sleep timeris operating. To confirm the sleep timer setting, pressSLEEP and the remaining time will be displayed for afew seconds. To cancel the sleep timer, press SLEEPrepeatedly until the display turns to Off.•Quick guide for menuoperationCall menu and for example: Select Language.1 Press INPUT SELECT to select TV mode.2 Press MENU. The TV menu screen will appear.AudioChannelLockSetupMain MenuPicture >>: Select ENTER:Set3 Press or to select “Setup”, then press orENTER.4 Press or to select “Language”, then press/ to select the desired language.…on the following pages the menu can be calledin the same way as here.5 Press EXIT to return to the normal screen.NOTE:If no buttons are pressed for more than about 60seconds, the menu screen will return to normaloperation automatically.•37I0521A_EnSp.indb 1937I0521A_EnSp.indb 19 3/24/09 4:20:11 PM3/24/09 4:20:11 PM