10 EnglishOPERATIONINTRODUCTION SETTINGS NETWORKCONTROLNETWORKOPERATIONNETWORKSETTINGSOTHER3 RECORDINGUse the following procedure to record monitored video.z Be sure to set the time when using the digital videorecorder for the first time. Recording is not possible untilthe time is set. (JP.5)1 Press the [REC/STOP] button.The REC/STOP indicator lights up, “REC” (i.e., the recordingsymbol) appears in the operation display and recording starts.z When recording for the first time, the default settings areused. (JINSTRUCTION MANUAL, P.83)z When “OVERWRITE” on the CONDITIONS SET> screen is set to “OFF” and the spaceremaining in the recording area becomes insufficient, theFULL indicator begins to flash. If recording is continuedbeyond this point, the recording area becomes full andrecording stops. Perform AREA FULL RESET to enablerecording. (JINSTRUCTION MANUAL, P.79)z Playback is possible even while recording.(JINSTRUCTION MANUAL, P.18)2 Press and hold the [REC/STOP] buttonfor approximately 3 seconds to endnormal recording.“REC” disappears from the operation display and recordingends.Use the following procedure to record monitored video for apreset length of time.z Be sure to set the time when using the digital videorecorder for the first time. Recording is not possible untilthe time is set. (JP.5)1 Set timer recording. (JINSTRUCTIONMANUAL)2 Press the [TIMER] button.The TIMER indicator lights up and the digital video recorderenters timer recording standby mode.z At the time specified for the start of timer recording, the REC/STOP indicator lights up, “REC” (i.e., the recording symbol)appears in the operation display and recording starts.z At the time specified for the end of timer recording, theREC/STOP indicator turns off and recording ends. TheTIMER indicator remains lit. If the [TIMER] button ispressed, the TIMER indicator turns off.z When “OVERWRITE” on the CONDITIONS SET> screen is set to “OFF” and the spaceremaining in the recording area becomes insufficient, theFULL indicator begins to flash. If recording is continuedbeyond this point, the recording area becomes full andrecording stops. Perform AREA FULL RESET to enablerecording. (JINSTRUCTION MANUAL, “Setting overwritepermission”, P.79)z Playback is possible even while recording.3 Press the [TIMER] button to end timerrecording before the end time.The TIMER indicator turns off and recording ends.[REC/STOP] button [TIMER] buttonFULL indicatorNormal recording02001-01-05 00:00:00 REC REPEAT EN ARecording symbolREC/STOPREC/STOPTimer recording02001-01-05 00:00:00 EN ATIMERTIMER