Sanyo HT30746 Owner's Manual

Also see for HT30746: Quick and easy setup Connection guide Service manual

6 Need help? Visit our Web site at www.sanyoctv.com or Call 1-800-877-5032NOTES:The on-screen message for digital search will appear with aprogress bar and percentile number displayed across thebottom of the screen (to indicate activity) as the search processcontinues.Channel information found during the channel search isstored in the Channel Scan Memory database. After the AllChannel Search is completed, the DTV will tune to the lowestDigital channel or lowest Analog channel if no digital channelsare found.If the DTV does not detect any digital or analog channels, amessage advising theviewer to check thecables and antennaconnections will ap-pear. In this case, youmust press theCHANNEL UP (CH )key again to repeatthe channel searchprocess. If after two searches the DTV still fails to detect anychannels, the DTV will tune to analog channel 3.These twochannel searches are necessary even if you plan to usethe DTV only as a monitor.If no analog or digital channels are found after thesecond search, All Channel Search will default to off-airanalog channels 2 through 69 and digital channel D3-1. Selectanalog channels using the remote control keypad. Seepage 12, item number 2.4 ANALOG ANTENNA SIGNAL (Optional)To change the initial ANALOG tuning systemsetup (from antenna to cable or cable to antenna),use the on-screen menu. See “Analog AntennaSignal” on page 16.2 INSTALL TWO “AAA” BATTERIESIMPORTANT NOTE: Spent or discharged batteries must be recycledor disposed properly in compliance with all applicable laws. Fordetailed information, contact your local County Solid WasteAuthority.• Install two “AAA” Batteries (notincluded) so that the “+” and“–” marks on the batteriesmatch the “+” and “–”marks inside the Remote.To review the Remotefunctions, go topages 12 ~ 13.NOTE: Use two “AAA”Alkaline batteries. Remove the batteries if the remote control will not be used for amonth or more. Weak batteries may leak and cause damage.(Normal battery life is roughly six months.) If batteries have leaked in the Remote Control Unit, carefully wipethe case clean and load new batteries.3 ALL CHANNEL SEARCHWhen the television is powered on for the firsttime, it automatically checks for the presence of anRF signal.• Press the POWER key toturn on the DTV.• Then press the CHANNELUP (CH ) key to automat-ically search for availablechannels: Digital (ATSC)and Analog (NTSC).The All Channel Search con-tains two processes that areexecuted simultaneously fordigital and analog channels.14 5 67 8092 3INPUTINFORECALLMENUCAPTION EXITVOLENTERTUNER MUTESLEEP14 5 67 8092 3INPUTINFORECALLMENUCAPTION EXITVOLENTERTUNER MUTESLEEPCHPOWER