Sanyo LCD-32XAZ10 Instruction Manual

Also see for LCD-32XAZ10: Service manual

Adjusting the PictureAdjusting the picture To adjust the picture:1Press 6or 5to highlight an option, press 3or4to adjust theoption; If a sub-menu exits, press ENTER to access the option, thenpress 3465to operate and press ENTER to confirm. You canselect:25 To close the menu, press EXIT button.Press MENU. The on-screen menu opens with the VIDEO menudisplayed, then press ENTER to access.! Picture Mode — Selects the picture mode. You can select:. Vivid (a bright and vivid picture). Standard (a standard picture). Gentle (a soft picture). User (user customized picture).Note: You can also press PICTURE on the remote control to selectthe picture mode.! Contrast — Adjusts the contrast.! Brightness — Adjusts the brightness.! Color — Adjusts the color saturation.! Sharpness — Adjusts the sharpness.! Hue — Adjusts the image tint(NTSC only).To adjust advanced video settings, in VIDEO menu press 6or 5tohighlight Advanced, press ENTER to access the sub-menu.3Press 6or 5to highlight an option, press ENTER to access theoption. Press 6or 5to select the setting and press ENTER toconfirm, or press 3or4to adjust the option. You can select:4! Color Temp — Selects the color temperature. You can selectWarm (to enhance the reds), Cool (to enhance the blues), orNormal.!picture noise (snow). You can select Low, Middle, High, or OFF.Noise Reduction — Selects the noise reduction mode to reduce! Display Mode — Selects the aspect ratio of the picture. You canselect:. Auto — Selects the correct aspect ratio automatically.. 4:3 — Shows picture in 4:3 display mode.. 16:9 — Shows a full-screen picture in 16:9 mode.. Zoom1 — Enlarges the picture vertically. The top and bottommay be cropped.. Zoom2 — Enlarges the picture both horizontally and vertically.The edges may be cropped.. Panorama — Stretches the picture at the edges, but maintains agood aspect ratio at the center of the screen.Note: You can also press ZOOM on the remote control repeatedlyto select the display mode.Noise ReductionDisplay ModeColor Temp NormalMiddle16:9VIDEOMove Enter ReturnMoveVIDEOOKContrastBrightnessSharpnessColorHueAdvancedPicture Mode User5050496061VividStandardGentleUserMoveVIDEOEnterContrastBrightnessSharpnessColorHueAdvancedPicture Mode User4949496261ReturnReturnMoveVIDEOEnterContrastBrightnessSharpnessColorHueAdvancedPicture Mode User4949496261ReturnOver Scan ON! Over Scan —(HDMI only) Turn this On to adjust the picture'sreproduction rate to 96% (available only when non-VESA signal isinput through HDMI jack). When Off is set, the picture'sreproduction rate is restored to 100%.Freezing the picturePress the FREEZE button to freeze the image on the screen (the videosources still run). Press again to restore.Note:! If a fixed image is displayed on the screen for a long time, that fixed image may become imprinted on thescreen and remain visible. Therefore do not freeze the picture for a long time.! In some mode, the FREEZE function can not work.To freeze the picture:18