A12 PCB_MS6A Printed Wiring Board DiagramsPower Board (SIDE:A) Power Board (SIDE:B)This projector is isolated from AC line by using the internal converter transformer.Please pay attention to the following notes in servicing1. Do not touch the part on hot side (primary circuit) or both parts on hot and cold sides (secondarycircuit) at the same time.2. Do not shorten the circuit between hot and cold sides.3. The grounding lead must be connected to the ground of the same circuit when measuring of volt-ages and waveforms.CAUTIONLine Filter Board (SIDE:A) Line Filter Board (SIDE:B)P.F. Board (SIDE:A) P.F. Board (SIDE:B)R/C Board (SIDE:A) R/C Board (SIDE:B)FN902FN903MainBoard“K8R”LensMotorsMainBoard“K8S”FN904P.F. Board “K6E”Lamp Ballast Unit “CB1”PowerBoard“K6F”Interlock Switch “SW904”SW902SW904 LF901Main Board“K8G”

service manual

Safety instructions

Specifications

Adjustments after parts replacement

Circuit protections

Mechanical disassemblies

Optical parts disassemblies

LCD panel/prism ass'y replacement

Lamp replacement

Optical adjustments

Condenser lens adjustment

Condenser lens-Out adjustment

Service adjustment menu operation

Circuit adjustments

Service adjustment data table

electrical adjustments

Test points and locations

Troubleshooting

Control port functions

Waveforms

Cleaning

IC block diagrams

electrical parts list

main board

parts description and reading in schematic diagram

Circuit block diagram

Power supply lines

Sanyo MS6A Service Manual

MS6A

MS6G

PLC-XU30

PLC-XU35

PS6A

PS6C

PS6G

PS6J