Sanyo PDG-DHT100L Owner's Manual

Also see for PDG-DHT100L - DLP Projector - HD 1080p: Brochure Brochure & specs Specifications Owner's manual Specifications

Contents

Sanyo PDG-DHT100L Owner's Manual Manual pdf 9 page image

9AC Power Cord for the United Kingdom:This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pinface of the plug. Should the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of thesame rating, marked thus ASA. If the fuse cover is detachable, never use the plug with the cover omitted. If areplacement fuse cover is required, ensure it is of the same colour as that visible on the pin face of the plug (i.e.red or orange). Fuse covers are available from the Parts Department indicated in your User Instructions.If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.The end of the flexible cord should be suitably prepared and the correct plug fitted.WARNING: A PLUG WITH BARED FLEXIBLE CORD IS HAZARDOUS IF ENGAGED IN A LIVE SOCKETOUTLETThe Wires in this mains lead are coloured in accordance with the following code:Green-and-yellow ············· EarthBlue ································· NeutralBrown ······························ LiveAs the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markingsidentifying the terminals in your plug proceed as follows:The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by theletter E or by the safety earth symbol or coloured green or green-and-yellow.The wire which is coloured blue must be connected to the terminal which is marked with the letter N or colouredblack.The wire which is coloured brown must be connected to the terminal which is marked with the letter L or colouredred.WARNING: THIS APPARATUS MUST BE EARTHEDThe AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.AC Power Cord for the United States and Canada:AC Power Cord used in the United States and Canada is listed by the UnderwritersLaboratories (UL) and certified by the Canadian Standard Association (CSA).AC Power Cord has a grounding-type AC line plug. This is a safety feature to be surethat the plug will fit into the power outlet. Do not try to defeat this safety feature.Should you be unable to insert the plug into the outlet, contact your electrician.THE SOCKET-OUTLET SHOULD BE INSTALLED NEAR THE EQUIPMENT AND EASILy ACCESSIBLEAC Power Cord RequirementComplianceFederal Communications Commission NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device,pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection againstharmful interference when the equipment is operated in a commercial environment. This equipmentgenerates, uses, and can radiate radio frequency energy and, if not installed and used in accordancewith the instruction manual, may cause harmful interference to radio communications. Operation ofthis equipment in a residential area is likely to cause harmful interference in which case the user will berequired to correct the interference at his own expense.Do not make any changes or modifications to the equipment unless otherwise specified in theinstructions. If such changes or modifications should be made, you could be required to stop operationof the equipment.WARNINGThis is a Class A product. In a domestic environment this product may cause radio interference in whichcase the user may be required to take adequate measures.Canadian Radio Interference RegulationsThis Class A digital apparatus meets all requirements of the Canadian ICES-003.GROUND