Sanyo PLC-EF30N Owner's Manual

Also see for PLC-EF30N: Specifications Service manual Specifications

45APPENDIXCheck number of lamp to be replaced on Lamp StatusDisplay.Loosen 3 screws on Lamp Cover and remove Lamp Cover.(See right figure.)13Loosen 2 screws and pull out Lamp Assembly to be replacedby grasping handle.4Turn off a projector and disconnect AC Power Cord. Allow aprojector to cool for at least 45 minutes.2Replace Lamp Assembly with a new one and tighten 2 screws.Make sure that Lamp Assembly is set properly6Follow these steps to replace lamp assembly.Replace Lamp Cover and tighten 3 screws.578Connect AC Power Cord to a projector and turn projector on.Reset Lamp Replacement Counter. (Refer to section "LampCounter Reset" on page 41.)NOTE : Do not reset LAMP REPLACEMENT COUNTERwhen lamp is not replaced.CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAYRESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.SCREWSLAMPCOVERSCREWSORDER REPLACEMENT LAMPReplacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give followinginformation to dealer. Model No. of your projector : PLC-EF30N Replacement Lamp Type No. : POA-LMP39(Service Parts No. 610 292 4848)Make sure which number of lamp needs to bereplaced on Lamp Status Display.Figure shows case of replacing LAMP 2.LAMP 1LAMP 2NOTES ON LAMP REPLACEMENTTo maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacingall 2 lamps at a time.LAMP REPLACEMENTCAUTIONDo not drop a lamp assembly or touch a glassbulb! Glass can shatter and may cause injury.CAUTIONFor continued safety, replace with a lampassembly of same type.Allow a projector to cool for at least 45minutes before you open Lamp Cover. Insideof a projector can become very hot.