10Part Names and FunctionsA built-in micro processor which controls this unit may occasionallymalfunction and need to be reset. This can be done by pressing theRESET button with a pen, which will shut down and restart the unit. Donot use the RESET function excessively.q COMPUTER IN 1 DVI-IConnect computer output (Digital/Analog DVI-I type) or MultiCard Imager (optional) to this terminal. (p17)TerminalCOMPUTER IN 1DVI - IMONITOR OUTS-VIDEOCOMPUTER IN 2 /COMPONENT IN /COMPUTER /COMPONENTAUDIO INAUDIO INR VIDEOL USBSERVICE PORTRESETMCI(MONO)(VARIABLE)AUDIO OUTq w e r t yu i oi S-VIDEOConnect the S-VIDEO output from video equipment to this jack.(p18)e AUDIO INConnect the audio output from video equipment connected tor or i to this jack. (When the audio output is monaural,connect it to L (MONO) jack.) (p17, 18)y AUDIO IN COMPUTER / COMPONENTConnect the audio output (stereo) from a computer or videoequipment connected to q or u to this jack. (p17, 18)r VIDEOConnect the composite video output from video equipment toVIDEO jack. (p18)u COMPUTER IN 2 /COMPONENT IN / MONITOR OUTThis terminal is switchable and can be used as computer input ,component input, RGB Scart 21-Pin Video input, or monitoroutput. Set the terminal up as either Computer input orMonitor output properly before using this terminal. An optionalcable is required when using this terminal as component inputor RGB Scart 21-Pin Video input. (p17, 18)(This terminal outputs analog signal from COMPUTER IN 1 DVI-Iterminal only when using as Monitor out.)o AUDIO OUT (VARIABLE)Connect an external audio amplifier to this jack. (p17, 18)This terminal outputs sound from AUDIO IN terminal (e or y).t USB (Series B)When operating the connected computer with the remotecontrol, connect USB port of your computer to this connectorwith a USB cable. (p17)w SERVICE PORTThis jack is used to service this projector.**Do not press this button. This button is used for optionalaccessories.