Sanyo PLC-SW20AR Owner's Manual

25COMPUTER INPUTMANUAL PC ADJUSTMENTThis projector can automatically tune to the display signals from most personal computers currently distributed. However,some computers employ special signal formats which are different from the standard ones and may not be tuned by Multi-Scan system of this projector. If this happens, projector cannot reproduce a proper image and the image may be displayedas a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.This projector has a Manual PC Adjustment to enable you to precisely adjust several parameters to match with those specialsignal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. Thisenables you to recall the setting for a specific computer whenever you use it.Note : This PC ADJUST Menu cannot be operated when "RGB" is selected on PC SYSTEM Menu (P22).Press MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT button to move a red frame pointer to PCADJUST Menu icon.12 Press POINT DOWN button to move a red frame pointer to theitem that you want to adjust and then press SELECT button.Adjustment dialog box will appear. Press POINT LEFT/RIGHTbutton to adjust value. Move a red frame icon to the item andpress SELECT button.PC ADJUST MENUPC ADJUST Menu iconAdjusts an image as necessary to eliminate flicker from the display.Press POINT LEFT/RIGHT button to adjust value.(From 0 to 31.)Fine syncThe number of total dots in one horizontal period. Press POINTLEFT/RIGHT button(s) and adjust number to match your PC image.Total dotsAdjusts horizontal picture position. Press POINT LEFT/RIGHTbutton(s) to adjust the position.HorizontalAdjusts vertical picture position. Press POINT LEFT/RIGHTbutton(s) to adjust the position.VerticalPress SELECT button to show the information of computer selected.Current modeAdjusts clamp level. When the image has a dark bar(s), try thisadjustment.ClampPress SELECT button at thisicon to adjust “Clamp,” “Displayarea (H/V)” or set “Full screen.”Press POINT LEFT/RIGHTbutton to adjust the value.Shows status(Stored / Free) of theselected Mode.Selected ModePress SELECT button atCurrent mode icon to showthe information of computerconnected.Current mode