Sanyo PLC-WL2500A Service Manual

Also see for PLC-WL2500A: Owner's manual Manual Manual Quick reference guide Owner's manual

Contents

Sanyo PLC-WL2500A Service Manual Manual pdf 52 page image

-52-Check the indicators for projector condition.• • • green. • • • red • • • off• • • blinks green.Q When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow. Whenthis indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lamp replace-ment counter after replacement of the lamp.Indicators and rojector condition• • • blinks red.TroubleshootingThe projector is off. (The AC power cord is unplugged.)The projector is in stand-by mode. Press the ON/STAND-BY buttonto turn on the projector.Projector conditionPOWERred/greenIndicatorsLAMP RE-PLACEyellowWARNINGredQThe projector is preparing for stand-by or the projection lamp is beingcooled down. The projector cannot be turned on until cooling is com-pleted and the POWER indicator stops blinking.QThe temperature inside the projector is abnormally high. The projec-tor cannot be turned on. When the projector is cooled down enoughand the temperature returns to normal, the POWER indicator stopsblinking and the projector can be turned on. (The WARNING indicatorkeeps blinking.)QThe projector detects an abnormal condition and cannot be turnedon. Unplug the AC power cord and plug it again to turn on the projec-tor. If the projector is turned off again, the projector has an internalpower error.QThe projector is operating normally.QThe projector is in the power management mode.QQ The projector has been cooled down enough and the temperaturereturns to normal. When turning on the projector, the WARNING indi-cator stops blinking.