Sanyo PLC-WM4500 Owner's Manual

Also see for PLC-WM4500: Owner's manual User manual Owner's manual Manual Manual

ENGLISHAbout projector conditionStatus DescriptionNormal ............................................................... Projector is operating normally.Power management in operation ........... Power management is operatingLamp failure ................................................... Lamp failure is occurringAbnormal temperature ......................... The temperature of the projector became too highStby after Abnormal Temp. ................. Projector detects abnormal temp. and sets into standby mode.Power failure ................................................ Power failure has occurred inside the projector. Projector is turnedoff. Unplug the AC cord and ask servicing to a qualified servicepersonnel.Power control and status checkCaution about turning on/off the projector via the networksWhen turning on/off the projector via the networks, preset the projector as fol-lows:1. Select “Setting” from the Projector menu.2. Select “Standby mode” from the Setting menu and set it as “Network”.If you set this function as "Network", the network part of the projector is con-stantly provided with power even if the projector is turned off. If you set this asEco, then the network part will be turned off when you turn off the projector.Consequently, you cannot turn on/off the projector via the networks.When a security (PIN code lock) has been set on the projector, you also cannotcontrol it through the network. To control the projector through the networktemporarily, execute "PJ lock suspend" command to unlock the security. "PJ locksuspend" is on setting sub menu [2] on Setting main menu. (+p.40)