Sanyo PLC-WXU300K Owner's Manual

Also see for PLC-WXU300: Owner's manual Quick reference guide Owner's manual Technical information Manual

Contents

Sanyo PLC-WXU300K Owner's Manual Manual pdf 66 page image

66Problem: – SolutionsNo power – Plug the power cord of the projector into the AC outlet.– See if the POWER indicator lights red.– Wait until the POWER indicator stops blinking to turn on the projectoragain. The projector can be turned on after the POWER indicatorturns red. See page 18.– Check the WARNING indicator. If the WARNING indicator lights red,projector cannot be turned on. See page 61.– Check the projection lamp. See page 64.– Unlock the Key lock function for the projector. See page 56.The initial display is not shown – Make sure Off or Countdown off are not chosen at displayfunction. See page 46.The initial display is not same – Make sure User or Off are not chosen at Logo (select)as the default set function. See page 47.Input signal switches automatically – Make sure Input search function is adjusted properly. See page 45.(or does not switch automatically)When the projector is on and you – That is the Filter warning icon. See page 56.press the input button, an iconother than the Lamp mode iconappears.An icon other than Input mode or – That is the Lamp replacement icon or the Filter warning icon. SeeLamp mode icon appears pages 55 or 58.Image is out of focus – Adjust focus of the projector. See page 23.– Provide proper distance between the projector and the projectionscreen. See page 13.– Check the projection lens to see if it needs cleaning. See page 63.– Moving the projector from a cool to warm place may result inmoisture condensation on the projection lens. In such cases, leavethe projector off and wait until condensation evaporates.Image is Left/Right reversed – Check the Ceiling/Rear function. See page 50.Image is Top/Bottom reversed – Check the Ceiling function. See page 50.Picture is not bright enough – Check if the Contrast or Brightness are adjusted properly. Seepages 34,41.– Check if Image mode is selected properly. See pages 33,40.– Check the lamp control function. See pages 25,55.– Check the LAMP REPLACE indicator. If it lights, the end of lamp lifeis approaching. Replace the lamp with a new one promptly. See page64.AppendixTroubleshootingBefore calling your dealer or service center for assistance, check the items below once again.–Make sure you have properly connected the projector to peripheral equipment as described on pages 14-16.–Make sure all equipment is connected to AC outlet and the power is turned on.–When the projector does not project an image from the connected computer, restart the computer.