Sanyo PLC-WXU30A Service Manual

Also see for PLC-WXU30A: Owner's manual Owner's manual Specification sheet

Contents

Sanyo PLC-WXU30A Service Manual Manual pdf 8 page image

-8-When the projection lamp of the projector reaches its end of life,the Lamp replacement icon appears on the screen and LAMPREPLACE indicator lights yellow. Replace the lamp with a newone promptly. The timing when the LAMP REPLACE indicatorshould light is depending on the lamp mode.Follow these steps to replace the lamp.LampFor continued safety, replace with a lamp of thesame type. Do not drop a lamp or touch a glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the Lamp cover. The inside of theprojector can become very hot.CAUtIoNScrewTurn off the projector and unplug the AC power cord. Letthe projector cool for at least 45 minutes.Remove the two () screws that secure the lamp. Lift thelamp out of the projector by using the handle.13Replace the lamp with a new one and secure the two ()screws. Make sure that the lamp is set properly. Closethe lamp cover.4Remove the one (1) screw on the lamp cover and openthe lamp cover.2Connect the AC power cord to the projector and turn onthe projector.6 Reset the lamp counter.See “Resetting the Lamp Counter” on the next page.5Lamp ReplacementHandleScrewCAUtIoNLamp CoverWARNING:TURN OFF THE UV LAMP BEFORE OPEN-ING THE LAMP COVERtop ControlLAMP REPLACEindicatorLamp replacement iconPress here andpull upward.✔Note:• The Lamp replacement icon will not appear whenthe Display function is set to “Off”, during “Freeze”,or “No show”.oRdER REPLACEMENt LAMPtype No. PoA-LMP111Service Parts No. 610 333 9740MaintenanceScrew