Sanyo PLC-XE50 Owner's Manual

Also see for PLC-XE50: Service manual

Contents

IndicatorsProjector ConditionPOWERred/greenWARNINGredLAMPREPLACEyellowThe projector is off. (The AC power cord is unplugged.)The projector is preparing for stand-by or the projection lamp isbeing cooled down. The projector cannot be turned on until cooling iscompleted.The projector is ready to be turned on with the ON/STAND-BY button.The projector is operating normally.The projector is in the Power management mode.The temperature inside the projector is abnormally high. The projectorcannot be turned on. When the projector is cooled down enough andthe temperature returns to normal, the POWER indicator lights redand the projector can be turned on. (The WARNING indicator keepsblinking.) Check and clean the air filters.The projector has been cooled down enough and the temperaturereturns to normal. When turning on the projector, the WARNINGindicator stops blinking. Check and clean the air filters.The projector detects an abnormal condition and cannot be turned on.Unplug the AC power cord and plug it again to turn on the projector. Ifthe projector is turned off again, unplug the AC power cord and contactthe dealer or the service center for service and checkup. Do not leavethe projector on. It may cause an electric shock or a fire hazard.AppendixCheck the indicators for projector condition. For Alarm indicator, see pages 53-54.• • • green. • • • red • • • off• • • blinks green.✽When the projection lamp reaches the end of its life, the LAMP REPLACE indicator lights yellow.When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lampreplacement counter after replacing the lamp. See pages 60-61.Indicators and Projector Condition• • • blinks red.✽✽✽✽✽✽✽