Sanyo PLC-XE50A Owner's Manual

Also see for PLC-XE50A: Service manual

Contents

Video InputPress the COMPUTER button on the remote control toselect Computer 1.Before using the COMPUTER button, select the correctinput source through Menu operation as described below.Use the MENU button to display the On-Screen Menu.Press the Point 7 8 buttons to move the red framepointer to the Input Menu icon.1Computer1Input MenuUse the Point ed buttons to move the red arrowpointer to Computer 1 and then press the SELECTbutton.2After the Source Select Menu appeared for Computer1, move the pointer to RGB (Scart) and then press theSELECT button.3COMPUTER buttonComputer 1Computer 2*Input Source Selection (RGB Scart 21-pin)Direct OperationMenu OperationMove the pointer (red arrow)to Computer 1 and press theSELECT button.Input Menu iconMove the pointer to RGB (Scart)and press the SELECT button.Source Select MenuRemote Control/COMPUTER buttonWhen the input source is coming fromvideo equipment connected to theCOMPUTER IN 1 terminal with a Scart-VGACable (not supplied), select RGB (Scart).RGB (Scart)✔Note:• Computer 2 is not displayed when the COMPUTER IN 2/MONITOR OUT terminal is set as Monitor out (p.48).• Computer 2 (COMPUTER IN 2/MONITOR OUT) canaccept only RGB signal.•When the Input Search function is set On1 or On2, theinput signal will be searched automatically (p.48)*See Note at the bottom of this page.37