19Terminals of ProjectorThe projector has two replaceable Interface board slots. The projector's functions can be extended by installingthe optional interface boards into the terminal slots. 2 vacant slots (Input 3 and 4) are provided in yourpurchasing the projector. For the Optional Interface Boards, contact sales dealer where you purchased theprojector.Pull out the interface board.Remove 2 Screws from an interface board.12Tighten screws to secure the interface board.Replace the interface board. Insert a new interfaceboard along Guide to fit Socket to inside Plug.34INPUT/OUTPUTTERMINALSGuideSocketPlug Figure shows Dual-SDI terminal.DVI / D-sub 15 Terminal 5-BNC / VideoTerminal2 TERMINAL SLOTS (Factory set)NOTES ON ORDERING OR USINGOPTIONAL INTERFACE BOARDWhen ordering or using Optional Interface Board, contactyour sales dealer. When contacting the sales dealer, tell theOption Control Number (Op.cont.No.) in the menu that islocated on the bottom of the information menu.(See page 28)✔Note:• In the replacement of interface board, turn off theprojector, press the Main On/Off Switch to Off andunplug the AC power cord from the AC outlet.Replacement of TerminalInstallationScrews
