Sanyo PLC-XP41 Owner's Manual

Also see for PLC-XP41: Brochure & specs Specifications Service manual Service manual

Sanyo PLC-XP41 Owner's Manual Manual pdf 23 page image

23COMPUTER INPUTThis projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to“COMPATIBLE COMPUTER SPECIFICATION” on page 26). When selecting Computer, this projector automatically tunesto incoming signal and projects proper image without any special setting. (Some computers need setting manually.)Note : Projector may display one of following messages.When projector cannot recognize connected signal as PCsystem provided in this projector, Auto PC Adjustmentfunction operates to adjust projector and message “Auto”is displayed on SYSTEM Menu icon.When image is not provided properly, manual adjustmentis required. (Refer to P24 and 25.)There is no signal input from computer. Make sureconnection of computer and a projector is set correctly.(Refer to TROUBLESHOOTING on page 40.)Auto––––PC SYSTEM Menu iconDisplays system beingselected.PC SYSTEM MENUSELECT COMPUTER SYSTEM MANUALLYPC SYSTEM Menu iconDisplays system being selected.Systems on this dialog box canbe selected.Press MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT buttons to move a red frame pointer to PCSYSTEM Menu icon.Press POINT DOWN button to move a red arrow pointer tosystem that you want to set, and then press SELECT button.12PC SYSTEM MENUCustom Mode (1~5) set in PCADJUST Menu. (P24, 25)This projector automatically selects PC system among those providedin this projector and PC system can be also selected manually.PC ADJUSTMENTAUTO PC ADJUSTMENTAuto PC Adjustment function is provided to automatically adjust Fine sync, Total dots and Picture Position to conform to yourcomputer. Auto PC Adjustment function can be operated as follows.Press MENU button and ON-SCREEN MENU will appear. PressPOINT LEFT/RIGHT button to move a red frame pointer to PCADJUST Menu icon.12 Press POINT DOWN button to move a red frame pointer toAUTO PC Adj. icon and then press SELECT button twice.This Auto PC Adjustment can be also executed by pressingAUTO PC ADJ. button on Remote Control Unit. Move a red frame pointer to AUTO PCAdj. icon and press SELECT button.PC ADJUST MENUAuto PC Adj.PC ADJUST Menu iconStore adjustment parameters.Adjustment parameters from Auto PC Adjustment can be memorizedin this projector. Once parameters are memorized, setting can bedone just by selecting Mode in PC SYSTEM Menu (P23). Refer tostep 3 of MANUAL PC ADJUSTMENT section (P25).NOTE Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adjustmentfunction. When image is not provided properly through this function, manual adjustments are required. (Refer to page 24,25.) Auto PC Adjustment function cannot be operated in Digital Signal input on DVI terminal and “RGB”, “720p (HDTV)”,“1035i (HDTV)” or “1080i (HDTV)” is selected on PC SYSTEM Menu.D-VGA, D-SVGA or D-XGAWhen digital computer signal is received on DVI terminal,above message is displayed on PC SYSTEM Menu icon.AUTOMATIC MULTI-SCAN SYSTEM