Sanyo PLC XP45L Owner's Manual

Also see for PLC-XP40/L: Comparison chart Specifications

Sanyo PLC XP45L Owner's Manual Manual pdf 39 page image

39APPENDIXLAMP REPLACEMENTWhen life of Projection Lamp of this projector draws to an end, LAMP REPLACEMENT indicator lights yellow. When aprojected image becomes dark or color of an image becomes unnatural, replacement of Projection Lamp is required.Turn off a projector and disconnect AC plug. Allow a projector tocool for at least 45 minutes.Loosen 2 screws with a screwdriver and pull out Lamp Assemblyby grasping Handle.13Replace Lamp Assembly with a new one and tighten 2 screwsback. Make sure that Lamp Assembly is set properly. ReplaceLamp Cover and tighten 2 screws.4Remove 2 screws with a screwdriver and open Lamp Cover.2Connect AC Power Cord to a projector and turn it on.6Follow these steps to replace lamp assembly.Reset Lamp Replace Counter (refer to section “Lamp ReplaceCounter” below).5LAMPASSEMBLYHANDLELAMP COVERNOTE : Do not reset Lamp Replace Counter when ProjectionLamp is not replaced.ORDER REPLACEMENT LAMPReplacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give followinginformation to dealer. Model No. of your projector : PLC-XP40L/PLC-XP45L Replacement Lamp Type No. : POA-LMP38(Service Parts No. 610 293 5868)LAMP REPLACE COUNTERBe sure to reset Lamp Replace Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMPREPLACE Indicator stops lighting.Turn projector on, press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button(s) tomove a red frame pointer to SETTING Menu icon (refer to page 35, 36).1Press POINT DOWN button to move a red frame pointer to “Lamp counter reset” and then press SELECT button.Message "Lamp replace counter reset?" is displayed. Move pointer to [Yes] and then press SELECT button.2Do not reset Lamp Replace Counter except after Projection Lamp is replaced.Another confirmation dialog box appears and select [Yes] to reset Lamp Replace Counter.3CAUTIONDo not drop a lamp assembly or touch a glassbulb! Glass can shatter and may cause injury.CAUTIONFor continued safety, replace with a lampassembly of same type.Allow a projector to cool for at least 45minutes before you open Lamp Cover. Insideof a projector can become very hot.