Sanyo PLC-XP46 Owner's Manual

Sanyo PLC-XP46 Owner's Manual Manual pdf 8 page image

NOTE ON POWER CORDAC Power Cord must meet requirement of country where you use a projector.Confirm an AC plug type with chart below and proper AC Power Cord must be used.If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.SETTING-UP PROJECTOR8PREPARATIONTo POWER CORDCONNECTOR on yourprojector.Projector side AC Outlet sideGroundTo the AC Outlet.(120 V AC)For Continental EuropeFor the U.S.A. and CanadaThis projector uses nominal input voltages of 100-120 V or 200-240V AC. This projector automatically selects correct input voltage. Itis designed to work with single-phase power systems having agrounded neutral conductor. To reduce risk of electrical shock, donot plug into any other type of power system.Consult your authorized dealer or service station if you are not sureof type of power supply being in use.Connect a projector with a peripheral equipment before turning aprojector on. (Refer to pages 11 ~ 13 for connection.)CAUTIONFor safety, unplug AC Power Cord when an appliance is notused.When this projector is connected to outlet with AC Power Cord,an appliance is in Stand-by Mode and consumes a little electricpower.CONNECTING AC POWER CORDConnect AC Power Cord (supplied) to a projector.AC outlet must be near this equipment and mustbe easily accessible.For the U.K.To the AC Outlet.(200 - 240 V AC)To the AC Outlet.(200 - 240 V AC)