Sanyo PLC-XTC50AL Service Manual

Also see for PLC-XTC50AL: Owner's manual Specifications Specifications

Contents

-91-Chassis DescriptionStatus read commandThe command is sent from PC to the projector with the format below;'CR' [Command] 'CR'Command: one character (refer to the command table below.The projector decodes the command and returns the 'Character string' with the format below;FormatThe tables show the typical command lists for controlling the projector. Please consult your local dealer forfurther information of other commands.command Function Projector return Projector statusCR0 Status Read00 Power On80 Stand-by mode40 Countdown0 Cooling down10 Power Malfunction8 Cooling down at the temperature anomaly4 Cooling down at Power Management mode04 Power Management mode after Cooling down1 Cooling down after the projector is turned off when the lamps are out.81 Stand-by mode after Cooling down when the lamps are out.88 Stand-by mode after Cooling down at the temperature anomaly.C Cooling down when the projector is turned off by the shutter managementfunction.8C Stand-by mode after cooling down by the shutter management function.CR6 Temperature Read S1 S S3S1 = Temperature at Sensor 1 (Temp A) (˚C)S = Temperature at Sensor (Temp B) (˚C)S3 = Temperature at Sensor 3 (Temp C) (˚C)(ex.) S1 = 1.3˚C, S = 3.4˚C, S3 = 34.5˚C--> The projector displays “1.3 3.4 34.5”(For each sensor, two digit and the tenth place numbers are displayedwith a space between each temperature.)? Communication failureThis Serial port does no available in the Eco standby mode. To use this function in the standby mode, the Normalstandby mode should be selected.