34Choose Video by pressing the INPUT button on the topcontrol or the VIDEO button on the remote control.Before using these buttons, correct input source should beselected through menu operation as described below.Press the MENU button to display the On-ScreenMenu. Press the Point 7 8 buttons to move the redframed pointer to the Input Menu icon.Press the Point ed buttons to move the red arrowpointer to Video and then press the SELECT button todisplay the Source Select Menu .12Move the pointer toVideo and press theSELECT button.VIDEOMove the pointer to thesource that you want toselect and press theSELECT button.Source Select Menu (VIDEO)Input MenuMove the pointer to the source that you want to selectand then press the SELECT button.3When selecting Auto, the projectorautomatically detects incoming video signal, andadjusts itself to optimize its performance. Theprojector selects connection in the followingorder:1. S-Video2. VideoAutoWhen video input signal is connected to theVIDEO jack, select Video.VideoWhen video input signal is connected to the S-VIDEO jack, select S-Video.S-VideoINPUT buttonVideoComputer 2Computer 1Input Source Selection (Video, S-Video)Direct OperationMenu Operation✔Note:When Monitor out is selected in the Terminal function (p44) ,Computer 2 is not displayed.✳ See Note at the bottom of this page.✳Input Menu iconVideo InputREMOTE CONTROLTOP CONTROL INPUT buttonVIDEO buttonON - OFFPOWERKINPUTWARNING LAMENU- VOSELECT