Sanyo PLC-XU70 Owner's Manual

Also see for PLC-SU70: Service manual

Contents

45SettingOn startWhen this function is “On”, the projector will beautomatically turned on just by connecting the AC powercord to a wall outlet.✔Note:Be sure to turn the projector off properly (see “Turning Off theProjector” on page 19). If the projector is turned off in the incorrectsequence, the On start function does not operate properly.SettingLamp controlRemote controlThis projector provides two different remote control codes;the factory-set, initial code (Code 1) and the secondary code(Code 2). This switching function prevents remote controlinterference when operating several projectors or videoequipment at the same time.When operating the projector in “Code 2”, both theprojector and the remote control must be switched to“Code 2”.To change the code for the projector;Select either “Code 1” or “Code 2” in this Setting Menu.To change the code for the remote control;Press and hold both the MENU and IMAGE buttonstogether for 10 seconds or more. After changing the code,make sure the remote control operates properly.Remote controlPress and holdMENU andIMAGE buttonsfor 10 seconds ormore.This function allows you to change brightness of thescreen.Normal ....normal brightnessAuto ........brightness according with the input signalEco ..........lower brightness reduces the lamppower consumption and extends thelamp life.