Sanyo PLC-XU83 Owner's Manual

Also see for PLC-XU83: Specifications Owner's manual Specifications

Contents

29Choose either Computer 1(Analog) or Computer 2 bypressing the INPUT button on the top control or press theCOMPUTER button on the remote control.Before using these buttons, correct input source should beselected through Menu operation as described below.Press the MENU button to display the On-ScreenMenu. Press the Point 7 8 buttons to move the redframed pointer to the Input Menu icon.1 Input MenuPress the Point ed buttons to move the red arrowpointer to either Computer 1(Analog) or Computer 2,and then press the SELECT button.2When selecting Computer 1(Analog), RGB inputsource will be selected directly.When selecting Computer 2, the Source Select Menuwill appear. Move the pointer to RGB and then pressthe SELECT button.3Computer 1(Analog/Digital)VideoComputer 2COMPUTER buttonComputer 2INPUT buttonInput Source Selection (RGB : Computer 1(Analog) / Computer 2 )Direct OperationMenu OperationComputer InputMove the pointer(red arrow) toComputer 1(Analog) and pressthe SELECT button.Input Menu icon✳ See Note at the bottom of this page.✳✳Remote ControlTop Control INPUT buttonCOMPUTER buttonON - OFFPOWERAUTINPUTWARNING LAMENUSELECT✔Note:•Computer 2 is not displayed when the COMPUTER IN 2 /COMPONENT IN / MONITOR OUT terminal is set as Monitor out.(p50)•Computer 2 (COMPUTER IN 2 / COMPONENT IN /MONITOROUT) can accept only RGB signal.•Wired, Wireless, Memory Viewer are for the Network function.See owner's manual (Additional Vol.) and owner's manual ofMemory viewer (optionally available).Move the pointer(red arrow) to RGB.Input MenuMove the pointer(red arrow) toComputer 2 andpress the SELECTbutton.Input Menu iconComputer2Computer InputWiredComputer 1(Analog/Digital)