Sanyo PLC-XU83 Owner's Manual

Also see for PLC-XU83: Specifications Owner's manual Specifications

Contents

64AppendixCheck the indicators for projector condition.• • • green. • • • red • • • off• • • blinks green.✽ When the life of the projection lamp draws to an end, the LAMP REPLACE indicator lights yellow.When this indicator lights yellow, replace the projection lamp with a new one promptly. Reset the lampreplacement counter after replacement of the lamp. See page 58 and 59.The projector is off. (The AC power cord is unplugged.)The projector is ready to be turned on with the POWER ON-OFFbutton.The temperature inside the projector is abnormally high. Theprojector cannot be turned on. When the projector is cooled downenough and the temperature returns to normal, the POWERindicator emits a red light and the projector can be turned on. (TheWARNING indicator keeps blinking.) Check and clean the air filters.Projector ConditionThe projector is preparing for stand-by or the projection lamp isbeing cooled down. The projector cannot be turned on until coolingis completed.POWERred/greenIndicatorsLAMPREPLACEyellowWARNINGredThe projector detects an abnormal condition and cannot be turnedon. Unplug the AC power cord and plug it again to turn on theprojector. If the projector is turned off again, disconnect the ACpower cord and contact the dealer or the service center for serviceand checkup. Do not leave the projector on. It may cause anelectric shock or a fire hazard.✽✽✽✽✽The projector is operating normally.The projector is in the Power management mode.✽✽The projector has been cooled down enough and the temperaturereturns to normal. When turning on the projector, the WARNINGindicator stops blinking. Check and clean the air filters.Indicators and Projector Condition• • • blinks red.Either of the projector network, or memory viewer function is inabnormal condition.✽