Sanyo VCB-3372 Instruction Manual

Contents

Sanyo VCB-3372 Instruction Manual Manual pdf 4 page image

PARTS NAMES1 Video output connector (VIDEO OUT: BNC type)Connect this connector to a device such as a VCR or monitorwith a VIDEO IN connector.2 12 V DC input terminal (12 V DC IN)Connect DC connecting cord from the AC adaptor to the12 V DC IN terminal on the camera.3 External sync composite video signal input connector(VS IN: BNC type)Connect to this connector the synchronizing signal outputfrom a synchronizing signal device or the composite signal ofa video distributor.4 Power indicator (POWER)Comes on when the power to the camera is on.5 Line phase adjustment screw (LINE PHASE)When using two cameras or more, the image on themonitor may roll vertically when switching sources. Thisrolling can be minimized by turning this screw.6 24 V AC input terminal (24 V AC, GND)7 Lens mount capThe cap is installed to protect the lens mount section.Remove the lens mount cap before installing a lens (soldseparately).8 Camera installation bracketThe bracket can be fixed at the top or bottom of thecamera. When fixing the bracket, be sure to use the longerscrews and install the shorter screws on the opposite side toseal the openings.CAUTION:When installing the camera support, select a locationthat can support the total weight of the camera andaccessories.1243(VCB-3372P)1 2 3 21781543(VCB-3374P)61 Shorter screws: M3 x 42 Longer screws: M3 x 63 Camera mountingscrew hole:1/4"-20 UNCEnglish 3