Sanyo VCB-3372 Instruction Manual

Contents

Sanyo VCB-3372 Instruction Manual Manual pdf 6 page image

PARTS NAMESF Flange-back adjustment screw (FLANGE BACK ADJ.)G Flange-back lock screw (FLANGE BACK LOCK)Flange-back adjustmentIf the pick-up surface is not correctly positioned with relationto the lens focal point, the picture will be out of focus (inparticular when using auto-iris power zoom lenses, soldseparately). If that is the case, adjust the flange-back positionas described below.1 Using a + screwdriver, loosen the FLANGE BACK LOCKscrew (M2:+).Set the zoom lens to the maximum telephoto position,set the focus using the focus ring on the lens.2 Set the zoom lens to the maximum wide angle position,set the focus using the FLANGE BACK ADJ. screw.3 Repeat steps 2 and 3, until the image stays in focus whenchanging from a telephoto shot to a wide angle shot.When the setting is complete, tighten the FLANGEBACK LOCK screw.MOUNTING THE LENSCheck the lens mountDo not use a lens if the length “L” is more than 7 mm.That may damage the camera and prevent properinstallation.Installation of a DC type auto-iris lens (soldseparately)A 1/3 inch CS mount type lens without EE amplifier circuitthat only uses a DC power source. This camera can receive(the A.I. LENS switch to the DC type) a CS mount type lenswithout the need of an adaptor.If the lens plug shape or wiring does not correspond, pleaseinstall the supplied plug as indicated in the pin layout table.L1GF13LOCK2 ADJ.English 5