Sanyo VCC-MD300 Technical Manual

Sanyo VCC-MD300 Technical Manual Manual pdf 37 page image

− 36 −[1] Camera Control Command Transmission1-1 Control using the Command ButtonThe camera unit can be controlled by clicking thevarious command buttons.The command data transmitted and received by thePC can be confirmed using the “SENDING DATA” and“RECEIVING DATA” windows.Application SoftwareCommand Button OperationZoom (TELE/WIDE) Controls the ZOOM function.Press down the button to start the ZOOM function.Release the button to stop the ZOOM function.Focus (FAR/NEAR) Controls the FOCUS function.Press down the button to start the FOCUS function.Release the button to stop the FOCUS function.Focus (Auto/Manual/1PushAF) Selects the FOCUS function mode.Shutter Speed (Shutter Speed) (−/OFF/+) Selects the shutter speed function mode.Click the OFF button to return to initial settings.Iris (Auto/Manual EI OFF/Manual EI ON) Selects the iris function mode.Iris (Level−/Level+) Selects the iris level.White Balance (Auto/Manual/1 push/3200K/5600K/FLUO) Selects the white balance mode.White Balance (R−/R+/B−/B+) Use the color R and B levels to adjust the white balance according tolightening conditions.BLC (OFF/MULT/CENT/MASK) Selects the BLC mode.AGC (ON/OFF) Selects the AGC mode. (AGC OFF is invalid when Day/Night is set toAUTO.)Version Displays the version of the connected camera.1-2 Input Command Data Controls(Refer to the command list)The camera unit can be controlled by entering thecommand data into the PC.Enter a specific protocol in the box within the“SENDING DATA” window (starting from box No.0).The camera is operated by clicking the “Manual Send”button. Similar to Item 1-1 (control using commandbutton), the data received from the camera can beconfirmed in the “RECEIVING DATA” window.In addition, display can be switched between adecimal/hexadecimal number display using “DEC”,“HEX”.[2] Communications ErrorAn error message displays when a communicationserror occurs and communication between the cameraand PC stops for several seconds.Communication can be stopped manually by clickingthe “Manual Stop” button.[3] RS-232C PortSelect the port to connect the RS-232C cable fromCOM1 to COM4 using the “Port” button[4] BAUDRATESelect the communication speed using the“BAUDRATE” button.[5] ID SET, ID KeyboardThe camera ID can be set in the “ID SET”, “IDKeyboard” tabs.(Does not apply to MD-300, 400 models)