Sanyo VHR-M340 Instruction Manual

PROGRAM TIMER RECORDINGSetting a Program Timer RecordingUsing the Buttons on the VCRIf the remote control does not operate or is not availableyou can use the buttons on the VCR front panel to set aprogram timer recording.NOTE: Eject the cassette tape, before proceeding withthe steps below.1 Press and hold the REC button on the front panel forabout 5 seconds.The Timer program menu appears.If the clock has not yet been set, the Clock setmenu appears.If necessary, the clock can also be set using theCHANNEL l(or j) and FFbuttons. (Refer to thenext step for button functions.)2 Use the CHANNEL l (or j) and FF buttons on theVCR front panel to program the timer.CHANNEL button: To select numbers or switchsettingsFF button: To select the next itemNOTE: If you enter the wrong number or setting,press the REW button to return to the wrong numberor setting, then enter the correct one.3 When the recording tape speed is set, press the FFbutton on the front panel to save the settings.4 When finished, press the REC button on the frontpanel to exit from the menu.5 Load a cassette.6 Press the POWER button.NOTES:œ Daily or weekly recording, or the program type cannotbe set using this method.œ Once a program timer recording has been set, it cannotbe erased using the buttons on the VCR front panel.Checking the Program Timer1 Turn on the power (TV and VCR).2 Set the TV to channel 3 or 4.3 Press the MENU button.The main MENU appears.4 Press the OK button.The programmed recordings are listed.NOTE: To display the program type, press the TYPEbutton after selecting the desired program using the ù(or û) button.5 When finished, press the MENU button to exit themenu.6 Press the POWER button.The VCR power turns off and the timer is set to therecording standby mode.The TIMER indicator lights.Clearing the Program Timer1 Follow steps 1 – 4 in “Checking the Program Timer”.2 Press the ù (or û) button to select the program to becleared.3 Press the CLEAR button.The erase confirmation screen appears.4 Press the CLEAR button again. (To cancel the eraseprocedure, press the SET button.)The selected timer program is erased from theprogram memory.5 When finished, press the MENU button to exit themenu.6 Press the POWER button.Changing the Program Timer1 Follow the steps under “Clearing the Program Timer”to erase the program that you wish to change.2 Follow the steps under “Timer Programming” to add anew timer program.30