Sanyo VPC-CG10BK Service Manual

Contents

- 18 -3-8. Adjust Specifications1. Lens Adjustment (Infinity)Preparation:POWER switch: ONIf using a ready-made collimator, set to infinity.Note:Do not vibrate during the adjustment.If readjusting after it has already been adjusted, wait for 15minutes or more for the unit to cool down first.Adjustment method:1. Set a distance of 0.5-1.0 cm between camera lens andcollimator lens. Do not touch the each lens.2. Set the camera so that it becomes center of the screen inthe collimator (zoom wide and tele).3. Double-click on the DscCalDi.exe.4. Select “Infinity Cal.” on the LCD “Test”, and click the “Yes”.5. Lens infinity adjustment value will appear on the screen.6. Click the OK.2. Lens Adjustment (1m) is carried out after this adjust-ment.3-6. The adjustment item which in necessary in part exchangeFactoryCordSettingLanguageSettingResetSettingLensAdjust-ment(1 m)AWBAdjust-mentUSBstorageinformationregistrationCCD WhitePointDefectDetectAdjustmentCCD BlackPoint AndWhite PointDefectDetectAdjustmentIn Lighted: Be sure to carry out the necessary adjustments after replacing the unit.: Adjustment is possible from the menu setting screen of the camera and by using the calibration software.LensAdjust-ment(Infinity)3-7. Updating the firmwareCheck the firmware version immediately after the CP1 board has been replaced. If an old version is being used, interfer-ence and errors in operation may also occur. If an old version is being used, update it with a newer version.Refer to 3-13. Firmware uploading procedure. (Page 21)COMPL PWB CP1COMPL PWB VF1COMPL PWB ST1COMPL PWB TB1ASSY FPC, CA1CameraCollimatorDsc Calibration xOKInfinity calibration :AF_TEMP_AD_I: 413PZ_BR: 4AF_BR: 4AF_I_WIDE: 4AF_I_MID1: 4AF_I_MID2: 13AF_I_TELE: 39IRIS_GAIN: -100IRIS_OFFSET: -31Copy