| 
English 1065 Specify the start point of the extract.h Use the procedure below to specify the frame from which the videoclip extract will start.h Play the video clip until approximately the desired point, pause thevideo clip, then play the video clip one frame at a time, stopping at thestart point of the extract. This will be the first frame of the extract.h If the start point of the video clip is also the start point of the extract,proceed to step 6.Play:After pausing playback, press and hold the SET button to the right forabout 2 seconds for forward playback, or to the left for reverseplayback.Pause:During playback, press the SET button.Accelerated playback:During playback, toggle the SET button to the left or right to changethe playback speed.Single frame:After pausing playback, toggle the SET button to the right to moveforward one frame, or to the left to move back one frame.6 Toggle the SET button up.h The start point of the video clipextract is set, and the screen tospecify the end point appears.h Specify the end point of the extractby following the same procedure asin step 5.portions>1 Toggle the SET button down.h The portion to be deletedswitches to the extractedportion.h Each time the SET button istoggled down, the sections todelete and the sections to saveare reversed.2 Specify the end point of the extract. The frame following the end pointof the extract will be the start point of the latter portion to be joined.00:01:10CUTPress shutter to saveEnd pointPortion to be deletedApproximate playback timeDownloaded From VideoCamera-Manual.com Manuals |
