Sanyo VPC-S1080 Instruction Manual

EN-1FCC STATEMENTThis device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, including interference that maycause undesired operation.Note:This equipment has been tested and found to comply with the limits for Class B digitaldevices, pursuant to Part 15 of the FCC rules. These limits are designed to providereasonable protection against harmful interference in a residential installation.Thisequipment generates uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of the followingmeasures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected. Consult the dealer or an experienced radio/TV technician for help.Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 ofthe FCC rules.Do not make any changes or modifications to the equipment unless otherwise specifiedin the manual. If such changes or modifications should be made, you could be requiredto stop operation of the equipment.NoticeIf static electricity or electromagnetism causes data transfer to discontinue midway (fail),restart the application or disconnect and connect the communication cable (USB, etc.)again.