9Switching onFollow the instructions on this page on how to switch on your TV setand the remote control before going on to following pages describinghow to use the channel set-up procedure.1. Insert two AAA batteries in the remote control.Precautions on using batteries:- Make sure you use the correct polarity.- Do not mix new and used batteries.- Do not use rechargeable batteries.- Do not expose batteries to excessive heat such as sunshine,them, as this could cause them to leak or explode.- Remove the batteries from the remote control if you are not usingit for a long period of time.2. Connect the power cable FIRST to the television, THEN to a mainssocket. (Note: If the power cable is connected to the television,please only connect the power cable to the mains socket.)Your TV set should only be connected to an AC supply. It must notbe connected to a DC supply. If the plug is detached from the ca-ble, do not, under any circumstances, connect it to a mains socket,as there is a risk of electric shock.Notesocket of the television may differ depending on the model.3. Connect an outside aerial to the ANTENNA IN socket at the backof the TV set.The aerial socket (75 OHM - VHF / UHF) can be used for4. When powered on, the TV will be turned on directly or be instandby mode.If the power indicator lights up, the TV set is in standby mode.Press the button on the remote control or on the TV set to turnon the TV.Switching off• To put the TV set into standby mode, press the button on theremote control. The TV set remains powered up, but with lowenergy consumption.• To switch off the TV set, unplug the mains socket from the mainsoutlet.Chapter 2 Connections and Setup