36The buttons on the side panel don’t work.• The side panel controls may be locked (disabled). Use the remote control to unlock the side panelcontrols by selecting the Button Block feature in the Parental Control Menu and press OK touncheck the box.• Unplug the TV for 10 minutes and then plug it back in. Turn the TV on and try again.The TV turns off unexpectedly.• The electronic protection circuit may have been activated because of a power surge. Wait 30seconds, and then turn the TV on again. If this happens frequently, the voltage in your housemay be abnormally high or low.• Unplug. Wait 10 minutes. Plug in again.You can’t select a certain channel.• The channel may be blocked or not approved in the Parental Control Menu.• If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (pressthe TV/VCR button on your VCR).• Press the TV button and then try to change channels.The stereo reception is noisy.• It may be a weak station. Use the Sound Menu and Analog TV Sound to choose mono.A black box appears on the screen.• Closed captioning might be on. Check Closed Caption in the Setup menu. Go to page 26 for moreinstructions.You are having problems with the HDMI Connection.• Make sure the HDMI or DVI component is turned on and the cables are firmly connected. Ifproblems still occur, turn off your component and reconnect it. Reset the power by unplugging thepower cord and plugging it back in.• If you are tuned to the HDMI 1, HDMI 2 or HMDI 3 INPUT and you’re receiving Unusable Signalmessage onscreen, press the INFO button on the remote. If Acquiring Channel appears in theChannel Banner, the HDMI or DVI device isn’t responding. Contact the manufacturer of theHDMI or DVI device for further assistance.• If you tune to the HDMI 1, HDMI 2 or HDMI 3 INPUT and you see snow, the video goes in and out,or the video takes a long time to appear, your HDMI or DVI component is havingtrouble sending video information to the TV. Reconnect your device. Reset the power byunplugging the power cord and plugging it back in. If problems persist, try connecting the YPb Pr jacks if they are available or contact the manufacturer of the HDMI or DVI componentfor further assistance.• If you have black bars on each side of your picture, the component you connected might have aswitch or a menu option allowing you to change the picture quality output that will fix this. Chooseeither 720p or 1080i.