TCL L32HDP60 User Manual

TCL L32HDP60 User Manual Manual pdf 22 page image

21Other InformationYou can’t select a certain channel.• The channel may be blocked or not approved in the Parental Control Menu.• If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).• Press the TV button and then try to change channels.The stereo reception is noisy.• It may be a weak station. Use the Sound Menu and Analog TV Sound to choose mono.A black box appears on the screen.• Closed captioning might be on. Check Closed Caption in the Setup menu.You are having problems with the HDMI Connection.• Make sure the HDMI or DVI component is turned on and the cables are firmly connected. If problems stilloccur, turn off your component and reconnect it. Reset the power by unplugging the power cord andplugging it back in.• If you are tuned to the HDMI 1, or other HDMI INPUT and you’re receiving Unusable Signal messagescreen, press the INFO button on the remote. If Acquiring Channel appears in the Channel Banner, theHDMI or DVI device isn’t responding. Contact the manufacturer of the HDMI or DVI device for furtherassistance.• If you tune to the HDMI 1, or other HDMI INPUT and you see snow, the video goes in and out, or thevideo takes a long time to appear, your HDMI or DVI component is having trouble sending videoinformation to the TV. Reconnect your device. Reset the power by unplugging the power cord and pluggingit back in. If problems persist, try connecting the Y Pb Pr jacks if they are available or contact themanufacturer of the HDMI or DVI component for further assistance.• If you have black bars on each side of your picture, the component you connected might have a switch ora menu option allowing you to change the picture quality output that will fix this. Choose either 720p or 1080i.The remote control doesn’t work.• Something might be between the remote and the remote light sensor on the front of the TV. Make surethere is a clear path.• The remote may not be aimed directly at the TV.• The batteries in the remote may be weak, dead, or installed incorrectly. Put new batteries in the remote.The Universal Remote control doesn’t work.This TV utilizes new remote control signals and may not be compatible with your existing universal remote (e.g.satellite box remotes, cable box remotes, and generic universal remotes, etc.). Over time, newer universalremotes will become available that should pick up the new TV codes.You are experiencing problems with V-Chip/Parental Controls.If the rating limits don’t work, you must lock the settings. Go to the Main Menu (press MENU on your remote),select Parental > Program Block > Rating Enable, Rating Enable is highlighted. Press ◄/► to select Onto have the rating limits take effect.What else can I do?If you’ve been through the Troubleshooting section and nothing has fixed your problem, try rebooting yourTV. Note that after a reboot, you may need to run your TV through the setup process again. To do a reboot,unplug the power cord from the wall outlet or power strip. Keep your TV unplugged for about 5 minutes. Thenplug in the TV and turn it on. See if the problem is fixed. If the problem remains, then please visit www.tclusa.com for updated FAQs or contact TCL Customer Support at the support number provided in your Warrantyunder “How To Get Service.”