TCS Basys Controls SZ1041A Product Manual

Also see for SZ1041A: Product manual

Contents

TCS Basys Controls SZ1041A Product Manual Manual pdf 3 page image

R2800 LAURA LANE • MIDDLETON, WI 53562 • (800) 288-9383 • FAX (608) 836-9044 • www.tcsbasys.com3Setupnote: If using remote sensor(s), the calibra-tion may need to be adjusted. See “Checkout andTroubleshooting” section.temPeRAtURe SenSoR SeleCtionThe dipswitches in the cover (shown above) must beset when using remote room, discharge, and/or outdoorsensors.Use the following guide to determine the dipswitch set-tings for your application.Using built-in room sensor only.(this is the default setting.)Using built-in room sensor withdischarge air sensor only.Using built-in room sensor withoutdoor air sensor only.Using built-in room sensor withboth discharge and outdoor airsensors.Using remote room sensor only.Using remote room sensor withdischarge air sensor only.Using remote room sensor withoutdoor air sensor only.Using remote room sensor withboth discharge and outdoor airsensors.KeyPAd ACCeSSThe dipswitches in the cover (shown above connectedwith ribbon cable) must be set in order to lock the userout of programming and/or to set the clock and sched-ule. Use the guide below to set these dipswitches foryour application. User access may also be limited withan access code set in programming. (The fan and sys-tem switches are enabled or disabled in programmingonly, and require no dipswitch placement.)Keypad access to both program-ming and clock setup. (this is thedefault setting.)no keypad access to programmingor clock setup.Keypad access to programmingonly.Keypad access to clock setup only.Once the dipswitches have been set and you have con-firmed that the sensors are reading correctly (and pro-gram and clock setup are finished, if locking out accesswith dipswitches), secure the cover to the base with thetwo set screws located at the top right and the left sideto prevent tampering.1 2 3 4 51 2 3 4 5REF A B