TEC B-442 Owner's Manual
                                  | |
Contents
| 
11. SELF TEST EM1-33046A11. SELF TEST11. SELF TESTTo initiate the Self Test Mode, depress the Feed key while turning on the printer.The printer will first calibrate the label length. If a label edge is not detected within 7", the printer will thenstop attempting to feed labels and treat the media as continuous thermal paper.Firstly, the printer will print a pattern to check the performance of the print head.Following the calibration of label length, the printer will print internal settings, including:1. Print head checking pattern.2. Printer type and firmware version3. Head Run Distance4. Serial port setting5. Code page6. Country code7. Print Speed setting8. Print Density setting9. Label Size setting10. Gap (Bline) Width and Offset Setting11. Backing Paper Transparence12. File list13. Memory availableAfter the self test is complete, reset the printer for use by turning the Power switch off and on. |
Related manuals for TEC TEC B-442
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine