TEC B-450-QP SERIES Owner's Manual

TEC B-450-QP SERIES Owner's Manual Manual pdf 12 page image

E5-15. SET UP PROCEDURE ENGLISH VERSION EO1-330055. SET UP PROCEDURE5.1 REQUIREMENTS FOR OPERATIONThis machine has the following requirements:• The host computer must have a serial port or centronics parallel port.• To communicate with host, either an RS-232C cable or Centronics cable is required.(1) RS-232C cable .......... 9 pins(2) Centronics cable ....... 36 pins• To print a label format, create the complete program using the interface/communication manual.n Interface CablesTo prevent radiation and reception of electrical noise, the interface cables must meet the followingrequirements:• Fully shielded and fitted with metal or metalised connector housings.• Kept as short as possible.• Should not be bundled tightly with power cords.• Should not be tied to power line conduits.n RS-232C Cable descriptionThe serial data cable used to connect the printer to the host computer should be one of the following twotypes:NOTE: Use an RS-232C cable with metric connector securing screws.5.1 REQUIREMENTS FOR OPERATIONDB-9SConnector to PCDB-9PConnector to PrinterDB-25SConnector to PCDB-9PConnector to PrinterPIN No.123456789HousingSignalN.C.RXDTXDDTRGNDDSRRTSCTSN.C.ShieldPIN No.123456789HousingSignalN.C.TXDRXDDSRGNDDTRCTSRTSN.C.ShieldPIN No.123456720SignalShieldTXDRXDRTSCTSDSRGNDDTRPIN No.123456789SignalN.C.TXDRXDDSRGNDDTRCTSRTSN.C.5.2 SETTING UP THE PRINTER• Place the printer on a flat, stable surface.• Use a grounded electrical outlet do not use adapter plug.• Be sure there is adequate room around the printer for easy operation and maintenance.• Keep your work environment static free.Fig. 5-1