Tait TOP Programming And Service Manual

Also see for T2000 Series: User guide User guide Installation guide System manual Information Pack

Contents

Tait TOP Programming And Service Manual Manual pdf 81 page image

M2259-00-200-812 Midian Programming 81Copyright TEL Encrypted Radio Programming and Service ManualNote: The flex shown is 228-22592-06A. Other versions of this flex differ slightly, but theconnection pads are the same. Refer to the PCB Information section.7.2.2 T2000 radio - Midian KL3 cable connection pointsTo connect the Midian programming cable according to the diagram below, first solder a shortlength of wire to the indicated pads, then attach the cable clip to it.Programming informationRefer to the programmer manual for PC settings, software commands and register values.Before programming the Midian encryption module, it is important to understand the meaning ofvarious identifiers in the programmer manual. Some of these are outlined in the table below:Note: Each encryption module is provided with a sheet for recording programmable settings.As some module settings cannot be read back, it is strongly recommended that allsettings be recorded for each radio and kept in a secure place.Security CodesWhen programming a Midian module, it is strongly recommended that you use themanufacturer’s default security codes. See the Midian programming manual for moreinformation on standard codes, and instructions for changing them if necessary.7.3 Direct Programming a TVS2-Tait Module in a TOP radioA TOP radio with Midian TVS2-Tait Encryption Module and using -07 version encryption flex(or later) can be direct programmed without opening the radio.Equipment PC with serial port, and if necessary 25pin D-range plug to 9 pin D-range socket adaptor. Midian KL3 programmer (supplied cable not required). Midian software to suit the module to be programmed. TOP radio to be programmed with flex (-07 version or later) and TVS2-Tait module fitted TOPA-EA-007G Encryption Direct Programming Cable (see page 86)Midian Identifier DescriptionANI and Primary Individual decode ID ANI for individual module addressingSecondary Decode IDs ANI Group number for paging or alerting a group of radiosSecurity Code Unique multi-digit code sets which code a module can decifer.Connect(yellow) clip hereprogram outConnect(green) clip hereprogram in