Tait tm9100 p25 Installation Manual

Also see for TM9100 Series P25: User guide

Tait tm9100 p25 Installation Manual Manual pdf 27 page image

TM8100/TM8200 Installation Guide Installing the Radio 27© Tait Limited October 20123.9 Installing the MicrophoneThis section describes the radio’s microphone connector and the informationrequired to connect the microphone and install the microphone clip.Notice The microphone grommet must be installed whenever themicrophone is plugged into the microphone socket:■ to prevent damage to the microphone socket when there ismovement of the microphone cord, and■ to ensure that the control head is sealed against water, dust andother environmental hazardsConnecting theMicrophone 1. Plug the microphone into the microphone socket.2. Slide the grommet along the microphone cord and push two adjacentcorners of the grommet into the microphone socket cavity.3. Squeeze the grommet and push the remaining corners into position.4. Check that the grommet is seated correctly in the cavity.Installing theMicrophoneClipWarning Safe radio mounting! Mount the microphone whereit will not interfere with:■ the deployment of passenger airbags■ the vehicle operator controls■ the vehicle operator’s viewNotice Only install the microphone clip provided. If a non-standardmicrophone clip is used, the correct operation of the microphone hook-switch cannot be guaranteed.Install the microphone clip in the most convenient location using the screwsprovided. The microphone must be within reach of the user but in such aposition that the PTT (press-to-talk) key cannot be inadvertently activatedor jammed.Figure 3.7 Correct remote cable grommet seatingmicrophonegrommetcontrol head