Settings Quick start guide26 Setting the print head gap The printer features automatic print head gap adjustment to the thickness of the pa-per used. In setup mode, you can enter a correction value to modify the head gapthat is normally determined automatically. This correction is useful for modifyingthe appearance of the type face. This correction will modify the appearance of thefont. It may be necessary to obtain optimum printing results on certain paper types.The AGA (automatic gap adjustment) function must be set to “always” or “once”.For more detailed information, refer to the User guide on the Online CD-ROM.Press the Setup key. The printer changes to setup mode.Press the Adjust (2) key.Press the Head (1) key.Use the < (2) or > (3) key to set the range within which the automatic gap adjust-ment is to be corrected. You can select values in the range from -10 to +10. Valuesfrom 0 to -10 reduce the distance between the print head and the paper, positivevalues increase the distance.Confirm the input by pressing the Set (1) key.Press the Setup key. The printer returns to the initial status.Negative values decrease the print head gap, positive values increase it. Changingthe automatically determined value may have a strong effect on the printing qual-ity. The setting made will be retained after switching off the printer.Adjust PaprpathMenu Char OnlineSetup21 3 4TOFHead Tear OnlineSetup21 3 4Head= 0 *Set < > Exit OnlineSetup21 3 4Quick Start-en.book Seite 26 Dienstag, 22. Juni 2004 1:33 13